Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
11th October 2021, 09:01 PM #1Member
- Join Date
- Jun 2016
- Location
- Sydney
- Posts
- 87
Dovetail table saw blade - right hand tilt - 9.5 degrees (1:6)
Brand new right hand tilt 250 mm (10 inch) table saw blade for cutting dovetails. I stuffed up and ordered a right hand tilt blade when I needed a left hand tilt blade (for saw stop). This blade was custom made by the saw blade genius at Henry Bros Sydney using a FREZITE blade. Blade is set for a 1 in 6 dovetail or 9.5 degrees for a table saw that has the capability to tilt right. A table saw blade that can get dovetails will change your life! They are that good. As can be seen in photos, this is brand new in box never been used. It cost me $150, will sell for $125 which includes postage (about $25).
Thanks Wiggy
IMG_1807.jpgIMG_1805.jpgIMG_1806.jpgIMG_1804.jpgIMG_1808.jpgWIGWOOD https://www.medalboxes.com.au
-
11th October 2021 09:01 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
11th October 2021, 09:11 PM #2
Cant you just send it back and have it done the other way?
-
13th October 2021, 08:17 PM #3Member
- Join Date
- Jun 2016
- Location
- Sydney
- Posts
- 87
I have a saw stop, the process of making an ATB to a dovetail grind uses up some of the meat in the the teeth, if I was going to change it to the other side it would have to use up double the amount teeth material and it would not meet the requirements for using the saw stop breaking system.....but, yes, I did think of it....
WiggyWIGWOOD https://www.medalboxes.com.au
Similar Threads
-
saw blade tilt both ways?
By Albert in forum TABLE SAWS & COMBINATIONSReplies: 5Last Post: 9th July 2021, 12:21 AM -
Deep Drilling straight and on 90 degrees using a small 2mm drill bit and hand drill?
By l2oBiN in forum GENERAL & SMALL MACHINERYReplies: 6Last Post: 18th January 2016, 04:08 PM -
Setting TS blade tilt and Mitre gauges
By inferno6688 in forum HAND TOOLS - POWEREDReplies: 15Last Post: 14th January 2009, 05:42 PM -
Tilt top table WIP
By Toolin Around in forum WOODWORK - GENERALReplies: 39Last Post: 4th March 2008, 01:41 PM -
Left vs Right Tilt Blade
By cypher in forum TABLE SAWS & COMBINATIONSReplies: 2Last Post: 5th January 2008, 03:42 PM