View Poll Results: BEST RECTANGULAR BOX
- Voters
- 58. You may not vote on this poll
-
ENTRY NUMBER 3
0 0% -
ENTRY NUMBER 6
4 6.90% -
ENTRY NUMBER 7
5 8.62% -
ENTRY NUMBER 9
3 5.17% -
ENTRY NUMBER 11
13 22.41% -
ENTRY NUMBER 12
3 5.17% -
ENTRY NUMBER 13
2 3.45% -
ENTRY NUMBER 14
1 1.72% -
ENTRY NUMBER 15
1 1.72% -
ENTRY NUMBER 16
11 18.97% -
ENTRY NUMBER 17
15 25.86%
-
19th March 2010, 04:30 PM #1WWF Box Challenge Guest
2010 Box Challenge - RECTANGULAR BOX ENTRIES
Here are the entries received for the 2010 WWF Box Challenge - RECTANGULAR BOX SECTION
-
19th March 2010 04:30 PM # ADSGoogle Adsense Advertisement
-
16th May 2010, 03:37 PM #2WWF Box Challenge Guest
entry number 6
Entry Section: Rectangular Boxes
Entry Type: Novice
Box Dimensions: 100mm high, 161mm wide and 261mm long.
Intended use: Treasure!!
Made From:
Lid top... Bandsawn Silky Oak veneers cut from a small gnarly lump, no specific
design, pattern was completely dependant on revealed grain, made up as I
went along until the layon was suitable size for a lid.
Lid btm...Quartersawn Silky Oak from straight timber. Both veneers laminated
onto 6mm reclaimed MDF.
Box btm...Quartersawn Silky Oak laminated onto 6mm MDF, one side only (btm
side)
Sides, front/rear...10mm thick solid Jacaranda, sides...10mm thick solid
Silky Oak, these pieces came from timber which included a small branch.
Handmade Hinges...Beefwood and Brass.
Front decoration/knob...Beefwood.
Lower box inside...flocked (red).
Construction...10mmx10mm box joints for the sides, lid and btm panels are
fitted into a narrow rebate the width of the thickness of the panel to be
flush with the sides, the hinges and front deco./knob are glued in position,
Titebond 2 glue used throughout.
The veneered panels were glued using West System in a press.
The hinges only allow opening to just over 90?
Finish... Hand sanded thru to 400 grit then applied Gilly Stephenson's Lemon
Cream furniture polish
Attachment 137051 Attachment 137052 Attachment 137053 Attachment 137054 Attachment 137055
-
16th May 2010, 04:01 PM #3WWF Box Challenge Guest
ENTRY NUMBER 3
Entry Section : Rectangular Boxes
Entry Type : Novice
Box Dimensions : 300 mm Long 125mm Deep 250mm Wide
Intended Use Jewellery Box
Made From :
Front Sydney Blue Gum, Sides species unknown rescued from an old wardrobe thrown out in a council cleanup, the lid is a combination of both. The base is 6mm radiate ply.
50mm Brass butt hinges. Inside is flocked in blue. The box is finished with 4 coats of Danish Oil sanded to 800 grit between each.
This is my first box and was made using a Gifkins Jig. It is a present for a friend of my wife’s for her 60th birthday
Attachment 137056 Attachment 137057 Attachment 137058 Attachment 137059 Attachment 137060
-
16th May 2010, 04:17 PM #4WWF Box Challenge Guest
ENTRY NUMBER 9
Rustic Red Ash, Pine base, Jarrah lid inserts, finished with Hard Shellac and Traditional Wax
Attachment 137066 Attachment 137067 Attachment 137068 Attachment 137069 Attachment 137070
-
16th May 2010, 05:24 PM #5WWF Box Challenge Guest
ENTRY NUMBER 7
Title: Pencil box
Entry Section: Rectangular boxes
Entry Type: Experienced
Box dimensions: 190mm wide x 280mm deep x 70mm high
Intended Use: Pencil box
Made from: Fijian Kauri (Agathis Moorei) carcass: tambour made from
artists pencils glued to Fijian Kauri strips, mounted on cotton duck;
tambour tracks lined with velvet.
Finish: Sanded to 800 grit, finished with white shellac and Livos
Kunos oil.
Special details: Agathis Moorei was named in honour of the first
director of the Sydney Royal Botanic Gardens, Charles Moore, and the
tree from which this box was made was planted by him in 1853. It died
prematurely in 2007, due to the roosting habits of the Grey-headed
Flying Fox, and had to be removed. It was milled and distributed to a
number of woodworkers and artists to make commemorative pieces, which
will be exhibited and sold to raise funds for the gardens. I was
fortunate enough to be invited to participate in this project.
Attachment 137078 Attachment 137079 Attachment 137080 Attachment 137081 Attachment 137082
-
16th May 2010, 05:31 PM #6WWF Box Challenge Guest
ENTRY NUMBER 11
Entry Section: Rectangular Boxes
Entry Type: Novice
Box dimensions: 310mm long x 210mm wide x 100mm deep Wall thickness is 10mm
Intended use: Document/Stationary Box
Made from: The main body, tray, hinges and feet is Figured Jarrah with the lid insert Curly Jarrah ex DjarilmariWA. The base and tray base are felt salvaged from a pool table over 3.6mm marine ply. Finished in White Shellac, EEE-Ultra Shine and Natural Wax. The lid also features a jarrah gasket.
Attachment 137083 Attachment 137084 Attachment 137085 Attachment 137086 Attachment 137087
-
16th May 2010, 06:18 PM #7WWF Box Challenge Guest
ENTRY NUMBER 12
Walnut, Sheoak and Maple
Finished with Hard Shellac and Traditional Wax
Attachment 137095 Attachment 137096 Attachment 137097
-
16th May 2010, 07:31 PM #8WWF Box Challenge Guest
ENTRY NUMBER 13
Entry Section: Rectangular Boxes
Entry Type: Novice
Box dimensions: 220mm long x 220mm wide x 150mm deep. Wall thickness is 10mm
Intended use: Keepsakes Box, given as engagement present.
Made from: The main body is Red Cedar. Lid insert is Tassie Myrtle burl. The base is pig skin suede over 3.6mm marine ply. Finished in Organoil Hard Burnishing Oil. The lid also features a Red Cedar gasket. The lid simply lifts off from 2 finger recesses, one left and right.
Attachment 137098 Attachment 137099 Attachment 137100 Attachment 137101 Attachment 137102
-
16th May 2010, 07:38 PM #9WWF Box Challenge Guest
ENTRY NUMBER 14
Walnut, Maple and Brass
Finished with Hard Shellac and Traditional Wax
Attachment 137103 Attachment 137104 Attachment 137105
-
16th May 2010, 08:14 PM #10WWF Box Challenge Guest
ENTRY NUMBER 15
Entry Section: Rectangular Boxes
Entry Type: Novice
Box dimensions: 310mm long x 210mm wide x 100mm deep Wall thickness is 10mm
Intended use: Document/Stationary Box
Made from: The main body is figured Huon Pine as is the tray. Lid insert, hinges and feet is Tassie Blackwood. The base and tray base are pig skin suede over 3.6mm marine ply. Finished in White Shellac, EEE-Ultra Shine and Natural Wax. The lid also features a Huon pine gasket. The wooden hinges also include wood pins.
Attachment 137108 Attachment 137109 Attachment 137110 Attachment 137111 Attachment 137112
-
16th May 2010, 08:20 PM #11WWF Box Challenge Guest
Entry Number 16
Section: Rectangular boxes
Type: Experienced I suppose
Dimensions 150mm x 150mm and 180mm height
Intended use: Jewellery and keepsakes box
Bubinga and Wenge. Each piece of Wenge railing turned into dowel at the ends, inserted and wedged.
Box drawer dovetailed.
All solid
Attachment 137189 Attachment 137190 Attachment 137191 Attachment 137192 Attachment 137193
-
16th May 2010, 08:26 PM #12WWF Box Challenge Guest
ENTRY NUMBER 17
Entry Section: Rectangular Boxes
Entry Type: Novice
Box Dimensions: 320mm long x 230mm wide x 120mm deep x 7.5mm wall thickness
Intended use: Keepsake/Document box
Made from: Qld Maple, Budgeroo and Queen Ebony with a Tassie Myrtle Burl Lid insert. Base is Marine Ply covered in pig skin suede. Finished with Hard Shellac sprayed on then Natural Wax
Attachment 137114 Attachment 137115 Attachment 137116 Attachment 137117 Attachment 137118
-
26th May 2010, 08:52 AM #13
Wow! great boxes. Hard to pick a winner from those, they all look winners to me. Great to see wooden hinges being used more in box making, adds a lot of character to the project. Well done guys.
Reality is no background music.
Cheers John
Similar Threads
-
2008 WWF Box Challenge Entries - Polls - Results - Comments
By coffenup in forum 2008 WWF Box ChallengeReplies: 199Last Post: 22nd June 2010, 09:42 PM -
2010 Box Challenge
By WWF Box Challenge in forum WOODTURNING - GENERALReplies: 6Last Post: 26th May 2010, 09:09 PM -
2010 Box Challenge
By WWF Box Challenge in forum ANNOUNCEMENTSReplies: 2Last Post: 31st March 2010, 11:04 PM -
Weisyboy's Pallet Challenge - Entries and Poll for Voting
By RufflyRustic in forum WOODWORK PICSReplies: 167Last Post: 2nd November 2008, 09:04 AM