Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Curved section jig
-
3rd September 2023, 04:58 PM #1Senior Member
- Join Date
- Nov 2013
- Location
- Far North, NZ
- Posts
- 165
Curved section jig
Gidday, had been thinking about making curved sections, like a camera shutter.
Cogitated for a while, and made this today, for 30 degree sections at 115mm radius.
Couple of pieces cut from scrap as a trial.
curve cutter 1.jpg curve cutter 2.jpg curve cutter 3.jpg curve cutter 4.jpg
Start with the timber clamped to the straight piece, cut the outer curve, move timber to the curved anchor and cut the inner curve.
Might need a bit of fettling yet.
-
3rd September 2023 04:58 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
4th September 2023, 05:26 PM #2Senior Member
- Join Date
- Nov 2013
- Location
- Far North, NZ
- Posts
- 165
Some cuts from the above.
375267668_7006288932728021_7342491666474319427_n.jpg
-
28th September 2023, 01:32 PM #3
I was wondering what these would be for until I saw your thread on the Lazy Susan. Very inventive.
Dallas
Similar Threads
-
Welding 120mm steel box section to 5 inch box section?
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 24th May 2021, 06:41 AM -
How would you make this curved section?
By TimberNut in forum WOODWORK - GENERALReplies: 25Last Post: 24th October 2010, 06:14 PM -
how would I carve a curved hole into a curved piece of wood?
By ane in forum WOODWORK - GENERALReplies: 1Last Post: 22nd February 2010, 07:30 PM