Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 6 of 6
-
5th September 2016, 06:05 PM #1
lathe only goes in reverse - help me
I have a vicmarc VL200 with Fuji FVR E7 invertor.
the problem is that the lathe spins in reverse fine and I can adjust the speed in reverse, but will not spin forward at all. Dead as dodo.
I have checked the little contact switch and that is fine. I have changed the cable from the push switch to the connector block, that is fine.
any ideas? I am wondering if the invertor needs resetting, but I cannot find out how to do it
any help really appreciated
-
5th September 2016 06:05 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
6th September 2016, 09:02 PM #2
Do you need forward and reverse or just forward variable speed?
If you do not need reverse at all, swap any two of the three power leads between the inverter and motor and that will change the motor direction.
If you want forward and reverse, I suspect that you will need to swap two of the motor supply phases as above, to get forward working, and then check the programing for the VFD (inverter) to make sure that it is configured for forward/reverse operation using the control panel you wish to use. There are a number of ways that the control panel can be configured, and the VFD needs to know what you are using in order to respond appropriately.I used to be an engineer, I'm not an engineer any more, but on the really good days I can remember when I was.
-
7th September 2016, 05:46 AM #3
It's a left handed lathe. Stand on the other side.
-
7th September 2016, 08:04 PM #4
Thanks Malb
I have obtained the instructions to reset the VFD and will try that at the weekend
-
11th September 2016, 03:14 PM #5
Got it fixed. It was a broken cable in the back -
-
11th September 2016, 11:56 PM #6Innovations are those useful things that, by dint of chance, manage to survive the stupidity and destructive tendencies inherent in human nature.
Similar Threads
-
Lathe models with reverse feature
By Lyle in forum WOODTURNING - GENERALReplies: 27Last Post: 3rd October 2014, 02:10 AM -
Why have a reverse switch on a lathe
By Dalboy in forum WOODTURNING - GENERALReplies: 9Last Post: 2nd April 2014, 11:00 PM -
Metric thread on imperial lathe, without reverse.
By Vernonv in forum METALWORK FORUMReplies: 65Last Post: 7th November 2013, 09:32 AM -
reverse mod for jet mini lathe
By mkypenturner in forum WOODTURNING - GENERALReplies: 5Last Post: 24th May 2012, 09:55 PM -
Reverse on a Lathe
By lubbing5cherubs in forum WOODTURNING - GENERALReplies: 19Last Post: 27th March 2007, 11:30 PM