Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: C & J 4jaw chuck.
-
17th June 2019, 09:50 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
C & J 4jaw chuck.
I have dug out of my stash a C & J ( Crowe & Jorgensen) Made in Australia 4 jaw chuck.
Its a 4 1/2” CO45#.
I don’t remember where this came from, I have the chuck key.
It was full of old grease/oil and the jaws where very hard to wind out.
I don’t know if it’s ever been used, had no backing plate.
Ive cleaned it up in thinners, oiled it and tried the jaws.
They are still too hard to move.
Looking at the back the screw retainers have an internal thread.
Would I be correct in assuming this would be for removal of them so I can try the jaws for fit.
H.
Read the full thread at metalworkforums.com...
-
17th June 2019 09:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
What to get - Metal lathe chuck vs wood chuck?
By Ed.. in forum WOODTURNING - GENERALReplies: 13Last Post: 4th October 2017, 11:21 PM -
collets : to chuck or not to chuck
By steamingbill in forum METALWORK FORUMReplies: 4Last Post: 26th July 2014, 10:17 PM -
removing chuck insert from vicmarc chuck
By doug3030 in forum WOODTURNING - GENERALReplies: 10Last Post: 25th April 2012, 02:10 PM -
Which beginners chuck should a woodchuck chuck
By dazzler in forum WOODTURNING - GENERALReplies: 16Last Post: 2nd July 2006, 10:58 PM