My machine is apart at the moment for new screws and some refurb. Opportunity to fit DROs, but I can't crank it through to check travels properly.
Hare and Forbes have a special on 3 axis Sino units, as cheap as eBay. My research suggests these are good units so I am about to pull the trigger.
I actually didn't care for Z axis but given the price will probably fit it on the quill. My question is my best attempt to measure travel suggests the X =720mm, Y= 470mm, Z=220mm options would be best.

Can anyone with a 42" machine with DROs confirm that I am ok with these?

Many thanks Craig


Read the full thread at metalworkforums.com...