Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
6th October 2018, 12:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Another Saw Arbor - This Time From Switzerland
I had posted and just now removed these photos in Simon's Pacific mill rebuild thread in response to his comment in this post - Rebirth of The Pacific FT-2 Mill
I had ventured out to Fiora Machinery yesterday in pursuit of a modular vice. There was a two piece Vertex vice but nothing modular. What I did find in a display case was the arbor below. It looked familiar with its finish and stamped sizing. I purchased my 13 from the Fiora brothers in 2010 and included in the purchase was a crate of accessories. One of those accessories was what looked like an unused long 1" cutter arbor with its full compliment of spacing collars.
The short arbor was probably removed from the crate prior to my purchase. Other than the slight corrosion it shows no evidence of use. Schaublin provided a wide size range of these arbors in both metric and imperial sizes.
The 13 cannot accommodate a 6" saw on the long arbor, the overarms get in the way. With this arbor and its keyed drive I have a few more options. Another handy acquisition.
IMG_20181005_144928740 (Large).jpg IMG_20181005_144945568 (Large).jpg IMG_20181005_145848019 (Large).jpg IMG_20181005_150348325 (Large).jpg
BT
Attached Images
- IMG_20181005_144928740 (Large).jpg (132.1 KB)
- IMG_20181005_144945568 (Large).jpg (143.8 KB)
- IMG_20181005_145848019 (Large).jpg (142.0 KB)
- IMG_20181005_150348325 (Large).jpg (243.9 KB)
Read the full thread at metalworkforums.com...
-
6th October 2018 12:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
More from Switzerland - an Erlach Drill chuck
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 20th July 2018, 12:00 AM -
More from Switzerland - A Reglus Clinometer
By Anorak Bob in forum METALWORK FORUMReplies: 7Last Post: 24th May 2015, 04:52 PM -
More from Switzerland - Watches and Machines
By Anorak Bob in forum METALWORK FORUMReplies: 11Last Post: 17th May 2012, 12:33 AM -
More from Switzerland - A Strama Grinder
By Anorak Bob in forum METALWORK FORUMReplies: 2Last Post: 31st July 2011, 02:42 PM -
Switzerland bound
By bdar in forum WOODTURNING - PEN TURNINGReplies: 6Last Post: 19th July 2008, 10:00 AM