I am chasing the tracking mechanism for a 915 x 50mm PA. Multitool.

The offset hole in tracking lever has worn badly. It is eggshaped by several thou.
Even worse the small spigot shaft that the track lever pivots on has become loose in its press fit hole. Normally, I would attempt to repair.
I don't have the original specs to repair the damaged parts and lack some of the required tools.

I can't imagine anyone wanting to part with a fully functioning Multitool and hoping to secure a unit a damaged in other places- not bar the tracking mechanism.

Grahame


Read the full thread at metalworkforums.com...