Thread: Brass Hex

G'day Ray,
Not sure what size you need but I've got some 3/4 AF already bored to just over 11mm, it's all yours if that helps.
Cheers,
Greg.

I having a guess but think you are looking for 6" long 1/2" hex,if thats the case try Edcon.

Ooops, my mistake sorry should have read slower.
Had it in my head that the extra half inch was to allow for cuts to make 6 x 1" pieces.
Offer still stands though if it helps.
Cheers,
Greg.

Originally Posted by kwijibo99

Ooops, my mistake sorry should have read slower.
Had it in my head that the extra half inch was to allow for cuts to make 6 x 1" pieces.
Offer still stands though if it helps.
Cheers,
Greg.

Greg many thanks for the offer length would be fine hole size to big as I'd need to tap it for a threaded rod.

So I'll pass

Originally Posted by pipeclay

I having a guess but think you are looking for 6" long 1/2" hex,if thats the case try Edcon.

Thats the one PC Edcon i think are at Blacktown and Revesby which would suit me fine even could get son to pick it up he works round the area. Just hope they do small orders don't want 3.6m

Ray, not exactly what you are after but Off Cuts Galore has some 9/16 x 500mm here Brass Hex 9/16" A/F x 500 mm-Lathe-Mill-Hobbie-Model-Weld for sale | quicksales.com.au item 13208588 may be worth dropping him a line to see if he has what you're looking for - I've found him pretty helpful in the past..........Lee

Try Offcuts Galore on Ebay.
Russell

Edcon will cut to size and would nearly bet my balls there cheaper than the offcut bloke,he makes a good profit on what he sells,his stuff is good for anyone without access to a supplier but apart from that its a bit dear.

Originally Posted by pipeclay

Edcon will cut to size and would nearly bet my balls there cheaper than the offcut bloke.

That's confidence...

I know you are in Sydney, but if you get stuck George White carries a pretty full range, and will cut to size.
http://www.georgewhite.com.au/produc...ycode=BS-H-ATF

Regards
Ray

Originally Posted by wheelinround

Suggestions for a supplier of some Brass hex rod. I am in Liverpool area.

I only need about 6"x1/2" which I then have cut to lenght to drill and thread internal.

Online there is Minitech, MINITECH ENGINEERING AND MODEL SUPPLIES

This is a link to their materials http://wic043u.server-secure.com/vs4...dept.asp?id=52

Thanks all some great leads there

I'll check out Reversby Endcon first see how I go. I may just buy more than I intended too