Been thinking about getting a set of these for one of my mills,

https://www.ebay.com.au/itm/3-Axis-D...UAAOSwG4xa6oDn

I wouldn't bother with expensive brand name DROs as the investment just isnt worth it for the work I do, however the sub $500 pricetag makes these a tempting option.
Anyone had them? do they work with ok repeatability? most of my work is measured with cheap verniers so they would hold similar tolerances and repeatability right? and anything super accurate I wouldn't rely on a DRO anyway

theres a number of various ones but they all seem to be basically the same,
I know the Igaging dro + with remote readout setups used to be a cheap budget option but they seem quite expensive now.


Read the full thread at metalworkforums.com...