Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
19th December 2013, 06:51 PM #1
HM52 horizontal arbour support clean up
Hi
Just going through some pictures on photo bucket and found the finished photos of the arbour support i posted here some time back, but the thread wont allow me to reply with the glitch we have.
It is a continuation of this thread
https://www.woodworkforums.com/f65/hm...ean-up-121464/
I had to bore out the support on one side and make up a threaded bush to straiten the clamping rod up.
I straitened up the cut vertical by just widening it by the minimum.
While I was there I added a oiling barbed which I have fitted a drip feeder to up on the ram.
I was able to use the grub screw hole in the bottom to gain access to drill the hole for the barb. As I have stated before my mill is s HM52B and one of the differences is the arbour support hss no center web where the barb is.
DaveUsing Tapatalk
-
19th December 2013 06:51 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Age
- 2010
- Posts
- Many
Similar Threads
-
CNC kit for HM52 mill?
By jhovel in forum CNC MachinesReplies: 2Last Post: 12th April 2012, 01:36 AM -
HM52 CNC Conversion
By RayG in forum METALWORK FORUMReplies: 182Last Post: 16th November 2010, 09:03 PM -
HM52 lathe
By Stustoys in forum METALWORK FORUMReplies: 6Last Post: 21st August 2010, 01:39 AM -
HM 52 Horizontal Arbor support clean up
By Dave J in forum METALWORK FORUMReplies: 13Last Post: 2nd August 2010, 06:52 PM -
S/h hm52
By Dave J in forum METALWORK FORUMReplies: 0Last Post: 23rd April 2010, 06:35 PM