Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 18 of 18
Thread: Metal Lathe Paint
-
31st July 2007, 02:58 PM #16
SENIOR MEMBER
- Join Date
- Jul 2004
- Location
- Adelaide
- Age
- 76
- Posts
- 768
I would go for the hammer or hammertone finish, it can be had in green, blue, grey etc. Used mainly for machinery, tools and the like. Easy to brush on for a professional finish.
Pedro
-
31st July 2007 02:58 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
31st July 2007, 04:50 PM #17
New Member
- Join Date
- Jul 2007
- Location
- brisvegas
- Posts
- 7
lathe paint
Howdy,
Just been doing this funnily enough
before
after
A White Knight one pack epoxy. Available from a huge green warehouse near you.
Still have not done the carriage, I have remove it to pull down to tighten it all up.
Cheers
Kombiman
-
31st July 2007, 06:10 PM #18
Cabinetmaker / Engineer
- Join Date
- May 2006
- Location
- Brisbane
- Posts
- 80
Hammertone
Thanks Pedro,
Not too keen on the hammertone look. I personaly think that a normal finish would look better on the lathe.
Cheers,
ShaneA man who thinks that it can't be done shouldn't interrupt a man who's doing it........
Similar Threads
-
New to all of this...Metal Lathe (A kinda project)
By Craig0563 in forum METALWORK FORUMReplies: 5Last Post: 3rd May 2007, 04:57 PM -
Metal Spinning Lathe
By echnidna in forum METALWORK FORUMReplies: 11Last Post: 1st February 2007, 09:19 PM -
woodturning with Metal Lathe
By Colinq in forum WOODTURNING - GENERALReplies: 7Last Post: 23rd February 2006, 10:43 AM
