I thought it was going to be something complex or complicated - the DOC is pretty impressive by itself
https://www.youtube.com/watch?v=CCDP6SFB2Io

Just doing the math on this and for those with more discrete dials, perhaps metric, and smaller machines taking less material per pass setting a ratio of 10:5.6 or 100:56 on infeed versus compound feed yields 29.24 degrees.

So if I was taking 0.25mm cuts I'd advance the compound 0.14 - it also makes it easier as my compound leadscrew has a lot of free play as it is currently, I'd only need to be advancing it, not in and back out, then back in with the occasional overshoot...then rinse repeat


Read the full thread at metalworkforums.com...