Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
15th May 2019, 06:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Parkanson Power Hacksaw 45 angle cut
Have acquired a Parkanson PHS and want to cut some angle iron at 45 degrees. The vice allows this but the material doesnÂ’t then fall within the blade stroke. Tried putting packing behind the angle iron to bring it within the cutting stroke but the material keeps coming loose. The saw cuts on the forward stroke and lifts on back stroke.
Suggestions please.
I am really happy with square cuts and have cut lots of square tube and solid square and round bar. I have put a new single phase motor in and am using a small electric fountain pump for coolant as the original was missing. Made a replacement motor cover and Have started repainting the machine green with Rustoleum but may start again with POV15 as I used it on an old lathe and am very impressed.
FC4274E9-8FD5-4BEB-A40B-8FAA9718A4DC.png
Attached Images
- FC4274E9-8FD5-4BEB-A40B-8FAA9718A4DC.png (6.68 MB)
Read the full thread at metalworkforums.com...
-
15th May 2019 06:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Parkanson Power Hacksaw
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 2nd April 2019, 05:50 PM -
Parkanson Power Hacksaw Oils
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 14th September 2018, 06:20 PM -
suitable surplus source for right angle worm drive gear box ?- power hacksaw
By desbromilow in forum METALWORK FORUMReplies: 7Last Post: 6th December 2012, 05:45 PM -
Parkanson power hacksaw
By Dave J in forum METALWORK FORUMReplies: 60Last Post: 18th February 2012, 08:09 PM -
restoring parkanson power hacksaw
By mistercartoon in forum METALWORK FORUMReplies: 29Last Post: 2nd July 2010, 09:31 AM