Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
12th April 2018, 01:41 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Re-registration of tool bit for a finishing pass?
Say one is turning some mild steel. Tool registration is complete, a number of passes are made until one is ready for a finishing pass or two.
Given a smooth finish is best achieved with a wide tool bit radius and roughing is best done with a smaller tool radius, it probably is best to change the tool bit, but then one needs to register the tool bit again. If the tool bit is being swapped, what is the best approach to re-register the tool bit again, given that probably very little material remains to be removed?
Read the full thread at metalworkforums.com...
-
12th April 2018 01:41 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
SOMETHING NEW! A tool pass-around to get the feel of it
By FenceFurniture in forum ANNOUNCEMENTSReplies: 12Last Post: 30th March 2012, 11:39 AM -
Shaper shear tool for finishing
By .RC. in forum METALWORK FORUMReplies: 3Last Post: 26th December 2011, 10:06 PM -
Poor finish with my finishing tool.
By simonl in forum METALWORK FORUMReplies: 87Last Post: 23rd December 2011, 11:25 PM -
Tracy Owen Finishing Tool
By ticklingmedusa in forum WOODTURNING - GENERALReplies: 3Last Post: 21st June 2011, 01:01 AM