Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Removing blind rolled pin
-
14th January 2019, 12:41 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,403
Removing blind rolled pin
What's the best way to remove a blind rolled pin.
I have a handle from a mates electric wheel chair, only does half a turn and has been sheared off. Thread size is 1/4"UNC and the rolled pin would be about 2.5mm
The handle is threaded internally, then to hold the threaded piece in place, they've installed a rolled pin, not all the way through, but about half way.
Blind Rolled Pin2.jpgBlind rolled pin.jpg
Hopefully the pics will explain it better.
Thanks in advance.
Kryn
Attached Images
- Blind rolled pin.jpg (89.3 KB)
- DSCF0653.jpg (69.8 KB)
- Blind Rolled Pin2.jpg (80.6 KB)
Read the full thread at metalworkforums.com...
-
14th January 2019 12:41 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
flattening hot rolled plate
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 1st August 2018, 08:00 PM -
Hot and cold rolled stock
By morrisman in forum METALWORK FORUMReplies: 5Last Post: 7th August 2012, 10:14 PM -
another rolled over tipper
By specialist in forum TRAILERS & OTHER FABRICATED STUFFReplies: 16Last Post: 13th April 2011, 10:50 PM -
Somebody hand me a rolled up newspaper...
By Slow6 in forum HAND TOOLS - UNPOWEREDReplies: 74Last Post: 26th September 2009, 12:43 PM