Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Seba Shaper
-
4th November 2018, 03:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Seba Shaper
I purchased this 450mm shaper at a local auction yesterday.
shaper.jpg
It needs a good clean and naturally the vise has gone missing but I'm happy to have it.
I will be transporting it home on a hiab truck. It is on a pallet so easy to load with a fork lift. I'm just not sure about the best way to sling it for removal. High center of gravity etc.
There may be enough room to sling under the casting at the front under the ram and there are some substantial pins screwed in the back end.
Too risky to sling under these? Or sling from the bottom and firmly lash slings tight around machine.
I don't have a manual so I would appreciate any comments re safe lifting.
John
Attached Images
- shaper.jpg (231.3 KB)
Read the full thread at metalworkforums.com...
-
4th November 2018 03:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Where to get shaper cutters from for Jet jws18ho shaper
By Marcus79 in forum WOODWORK - GENERALReplies: 6Last Post: 21st October 2015, 10:05 PM -
shaper
By jonroe in forum METALWORK FORUMReplies: 3Last Post: 27th September 2011, 12:02 AM -
TOS shaper
By Bryan in forum METALWORK FORUMReplies: 91Last Post: 16th March 2011, 05:58 PM -
Shaper vid
By .RC. in forum METALWORK FORUMReplies: 6Last Post: 1st October 2008, 11:03 PM