Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 31 to 35 of 35
-
18th September 2012, 10:12 AM #31New Member
- Join Date
- Jan 2012
- Location
- canada
- Posts
- 3
Sorry its when the transition is flat at the bottom i need 22'' ring to set flat on the floor Tkx
-
18th September 2012 10:12 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
18th September 2012, 10:28 AM #32GOLD MEMBER
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 7,775
I still don't understand what you are trying to do. Do you have a drawing or picture?#
Stuart
-
18th September 2012, 06:44 PM #33Senior Member
- Join Date
- Apr 2010
- Location
- Rural Victoria
- Posts
- 359
Is this what they call an 'offset' or 'eccentric' transition? Is one side 90 degrees to the horizontal aperture?
-
19th September 2012, 10:28 AM #34New Member
- Join Date
- Jan 2012
- Location
- canada
- Posts
- 3
Do this help u understand more SAM_0904.jpg
-
19th September 2012, 11:32 AM #35GOLD MEMBER
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 7,775
Indeed it does, though it only shows offset in one plane. So assuming its not offset in the other plane, all you need to do treat it as two separate parts split along the center line of the round duct. Drawing half of the top for one part and half of the bottom for the other part, just like Al B has done. Keep an eye on your true lengths as they will be a little more tricky that Al b's. Unless you want to make it in one part or need the joints somewhere else. then it will get more tricky.
It will likely be easier to make the 2" flange as a separate piece(depending on what tools you have)
Hope this gets you going. If not I'll try and remember just how to draw one of these things.
Stuart
Similar Threads
-
Thread on stainless steel square bar
By SBartleet in forum METALWORK FORUMReplies: 13Last Post: 30th October 2007, 11:47 PM -
How does Red Ash turn?
By cedar n silky in forum WOODTURNING - GENERALReplies: 15Last Post: 11th July 2006, 04:24 PM -
Round to square?
By corbs in forum HOMEMADE TOOLS AND JIGS ETC.Replies: 14Last Post: 23rd August 2005, 12:05 PM -
Making a round / cylindrical box
By samueolchoo in forum WOODWORK - GENERALReplies: 2Last Post: 29th April 2003, 10:14 AM -
Making rips square
By Grant Cassar in forum TRITON / GMCReplies: 5Last Post: 2nd July 2002, 12:19 AM