Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Tapered fitting to shaft
-
22nd May 2019, 06:30 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,432
Tapered fitting to shaft
My mate has a chipper/mulcher.
It threw a blade which bent the crank.
Removing the cutter disk from the crank, which is a taper fitting locked with an axial bolt proved extraordinarily difficult even with a gear puller. (bent the plate...)
The plate was off not long ago so I was surprised how difficult it was.
Even removing it after assembly (which was when the bend was found) was difficult.
He used grease on the shaft. Is this correct /ok/bad?
Russ
Read the full thread at metalworkforums.com...
-
22nd May 2019 06:30 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Fitting a tapered blade to a Bailey plane. Anybody got any words of wisdom?
By seanz in forum HAND TOOLS - UNPOWEREDReplies: 19Last Post: 14th April 2016, 01:22 PM -
Tapered shaft for chuck on slot mortiser - bad design?
By Johnnz in forum GENERAL & SMALL MACHINERYReplies: 0Last Post: 9th November 2013, 12:02 PM -
Bluing a tapered shaft
By jack620 in forum METALWORK FORUMReplies: 20Last Post: 9th April 2013, 07:02 PM -
tapered balusters
By chuck1 in forum WOODTURNING - GENERALReplies: 5Last Post: 3rd February 2013, 10:18 AM -
Fitting polishing wheel to tapered spindle
By Dengue in forum FINISHINGReplies: 6Last Post: 30th December 2012, 02:16 PM