This is a 5" cup wheel with a 1 1/4" bore, I need to make flanges and a spacer to mount it onto a 1/2" spindle. What diameter flanges should I use for this wheel? Is there a rule of thumb for flange diameters?
IMG_1386.jpg

The job is to reface these curved hardened steel cam followers which are 9/16" x 1 1/4" x 4" radius, taking off 10 to 15 thou will probably clean them up. I'll have the followers set up in a radiusing jig and sweep them past the above grinding wheel by hand. Once the follower has made contact with the wheel how much should I advance the follower for each sweep? Any thoughts suggestions observations gratefully received.
IMG_1388.jpg
Attached Images




Read the full thread at metalworkforums.com...