Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
-
4th January 2019, 12:00 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,424
First time welding and wondering what I'm in for.
Hey everyone! So i posted on here a few months ago in relation to making coffee table legs out of flat bar steel 50mm by 5mm. Got some great advice and ended up investing in a universal bender. It worked a treat!
But the time has come where I'm looking to make something a bit sturdier. I'm wondering if this picture is an achievable first welding project and roughly what price per meter I'll be paying for hollow rectangular mild steel?
Any advise would be greatly appreciated.
The table I'm making is a desk and will be 1.8m x 450mm.
It should be noted that i have done a 3 day welding course that covered the basics.
Thanks in advance!
from Sunshine coast QLD
Read the full thread at metalworkforums.com...
-
4th January 2019 12:00 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Welding Cast is difficult. I didn't know that at the time.
By MWF FEED in forum WELDINGReplies: 0Last Post: 7th October 2018, 10:20 PM -
Stoopid question time - Aluminium welding
By czzer in forum WELDINGReplies: 6Last Post: 4th December 2014, 07:37 PM -
Completing a Welding Apprenticeship Part Time
By BigL753 in forum WELDINGReplies: 1Last Post: 14th February 2012, 08:05 AM -
MIG Welding...time to give it a go
By UglyDan in forum WELDINGReplies: 60Last Post: 25th May 2010, 11:32 AM -
I was wondering...
By Wild Dingo in forum WOODTURNING - GENERALReplies: 28Last Post: 30th August 2006, 06:01 PM