Hello,

looking for info into making corners for a sheetmetal horse trailer top, the style I'm going for is similar to a streamline camper, see picture, which has segmented corners.

I did an attempt using sheetmetal 'pie cuts' which i then bent around the frame, unfortunately it's not working out. Probably have the geometry of the pie cuts all wrong, anybody have experience, tips/tricks about this?

Thanks in advance, Christof.

Streamline look i'm trying to copy:

8e28_12.JPG

Where I'm currently at, trying to fill in these front corners, there is still one of the 'test' pie cuts installed in these pictures.

20190202_165301.jpg

20190202_165305.jpg
Attached Images




Read the full thread at metalworkforums.com...