Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Vintage clamps.
-
7th February 2018, 11:30 AM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,431
Vintage clamps.
Can never have enough clamps... I also like putting them back into action.
Picked up these two a while back..the F-clamp is an Aussie made Gyrex... has been a bit abused in its time, and looks like the screw and nut have been replaced..done a good job,although the handle is a bit puny.
The other is a fabricated type.. the frame is made from two pressed sides that that have been welded around the perimeter...it too has been subjected to stress beyond its capabilities and is twisted.
Hoping that someone has either of these clamps ..as i would like to copy the pad dimensions.
Ken.
Attached Images
- GEDC0979gy.jpg (74.5 KB)
- GEDC0992.JPG (149.0 KB)
- GEDC0983.JPG (218.5 KB)
- GEDC0981.jpg (70.8 KB)
- GEDC0989.JPG (187.1 KB)
Read the full thread at metalworkforums.com...
-
7th February 2018 11:30 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Pipe clamps/long clamps advice
By StuartB89 in forum WOODWORK - GENERALReplies: 2Last Post: 14th January 2017, 06:38 PM -
Vintage (or not so vintage) machine lamps
By jcge in forum ANTIQUE AND COLLECTABLE TOOLSReplies: 2Last Post: 9th July 2014, 09:42 AM -
Sash clamps versus Bessey K series clamps
By zelk in forum HINTS & TIPSReplies: 8Last Post: 6th September 2007, 10:24 PM