Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 1 of 1
Thread: Parkanson Power Hacksaw Oils
-
14th September 2018, 06:20 PM #1Most Valued Member
- Join Date
- Aug 2015
- Posts
- 4,433
Parkanson Power Hacksaw Oils
A while ago I acquired an old Parkanson 6"×6" 3 phase power hacksaw. After a bit of tinkering, new pulley for the coolant pump, some castors for moving it around and a few new belts I have got it running well and cutting straight. It now just needs a good clean and some coolant and it's good to go. One bit of info I have not been able to locate is what type of oil to use to lubricate the various slide and rotating mechanisms. The model plate mentions that only Caltex Rando G oil should used, and as far as my Googling has gone I can't find any details on the old Caltex lubricants and what the modern equivalents would be. Any advice on this would be greatly appreciated.
Sent from my SM-G935F using Tapatalk
Read the full thread at metalworkforums.com...
-
14th September 2018 06:20 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Posts
- Many
Similar Threads
-
Parkanson power hacksaw
By Dave J in forum METALWORK FORUMReplies: 60Last Post: 18th February 2012, 08:09 PM -
Power Hacksaw
By Auskart in forum METALWORK FORUMReplies: 4Last Post: 4th September 2011, 09:37 PM -
restoring parkanson power hacksaw
By mistercartoon in forum METALWORK FORUMReplies: 29Last Post: 2nd July 2010, 09:31 AM