Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
20th August 2014, 08:47 AM #1
What's a good 3" drill press vice?
As the subject guys... I'm starting to look for a 3" (possibly upto 4") vice for my drill press.
I don't care for cheap Chinese stuff and would much rather have a quality new one or an old quality one.
I've heard the old Waldown ones are good but seem to be as rare as the proverbial hens teeth, likewise with the Dawn ones.
I think I've heard good things about Vertex and Palmgren in the past, but aren't sure.
I use the drill press for holes that I can't do in the lathe so accuracy is generally important.
So there's the rub, what would you recommend?
Thx
Jon
Thx
Jon
-
20th August 2014 08:47 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
20th August 2014, 11:40 AM #2.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
Hello Jon,
I have a bit of a collection of vices. https://www.woodworkforums.com/showth...92#post1286292 Palmgrens are OK, I have found the little 1 1/2" wide vice with the bolt down lugs extremely useful. The adjustable angle vice I've used once.
The vice I most often use on the drill is the standard 3" Waldown. It is equipped with hold down clamps which bolt into the table's tee slots ensuring security. Nothing worse than a vice moving went you don't want it too. There is one on eBay at the moment - http://www.ebay.com.au/itm/Waldown-M...item2c8993b450 Sadly the vice has a few holes in it.
Bob
-
20th August 2014, 08:06 PM #3
-
20th August 2014, 08:46 PM #4.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 5,650
I have Mike. I even have a rough drawing of a clamp that I think I posted here. l will have a look when I get off the bus. They are pretty simple things and wouldn't be difficult to make if that's why you are asking.
That was easier than I thought! - https://www.woodworkforums.com/showth...17#post1705717
Bob.
-
21st August 2014, 08:18 AM #5
Mike, you beat me to it! Thanks for the clamp sketch Bob.
Thx
Jon
Similar Threads
-
drill press vice
By eskimo in forum METALWORK FORUMReplies: 31Last Post: 22nd December 2014, 03:19 PM -
drill press vice woes
By Grahame Collins in forum METALWORK FORUMReplies: 9Last Post: 20th May 2011, 02:18 AM -
Advice on drill press vice please?
By BoomerangInfo in forum WOODTURNING - PEN TURNINGReplies: 18Last Post: 20th May 2009, 08:54 PM -
drill press vice
By Redback in forum GENERAL & SMALL MACHINERYReplies: 9Last Post: 5th April 2005, 01:19 PM