Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: LS positioner - position
-
29th December 2010, 06:37 PM #1
LS positioner - position
Hi Guys
I’ve had the Wonderfence for a few years now, bought in a sale at Carbitec and this Xmas bought the 17” LS positioner (metric) in their sale also (whoopee).
My current small homemade router table is too short for the positioner and I intend to make a 750mm wide x 1600 mm long combined router table/workbench. Now I’m a “work from the manual” sort of guy usually but it seems to me that fitting the LS base 17” back from the router centre only give a max panel size to route of circa 250 mm. But if I fix the base as far back down the carriage as possible – circa 23” (that is from the front of the W/fence) then I increase the possible panel size to 350 mm.
Am I missing something here?Fantastic cheese Grommit!!
-
29th December 2010 06:37 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
29th December 2010, 08:49 PM #2Intermediate Member
- Join Date
- Oct 2008
- Location
- Waikato, New Zealand
- Posts
- 38
Nope, not missing anything - if you plan to always use the wonder fence, I have done similar on my table with no problems.
-
15th January 2011, 03:12 PM #3
Hi Guys!
What I've done in the past is to fix the positioner to a sheet of 20mm ply and then move it around the table and clamp it down where needed.
Since I was using a table saw extension for my router, I also invested in a pair of mag-locks which eliminated the need for clamping...
Rob
Similar Threads
-
Centering on an LS positioner
By Pacwind31 in forum INCRA JIGSReplies: 18Last Post: 19th February 2010, 12:10 PM -
LS positioner thick timber
By Lofty01 in forum INCRA JIGSReplies: 5Last Post: 25th September 2008, 11:57 AM -
Newbie Through Dovetails LS Positioner
By Lofty01 in forum INCRA JIGSReplies: 2Last Post: 21st March 2008, 03:22 PM -
LS Positioner & Miter1000 on SCM C35 Combi
By Stringy in forum INCRA JIGSReplies: 3Last Post: 25th February 2007, 07:21 PM -
Incra Mike (micro positioner) ??
By scooter in forum WOODWORK - GENERALReplies: 3Last Post: 10th December 2004, 12:47 AM