Thread: Newbie Through Dovetails LS Positioner

Have you looked at the Leigh Jig web page they have video's that may help
les

Originally Posted by Lofty01

Hi peeps
In need of a few pointers badly, trying to joint through dovtails with above router fence setup.
using template DOVS 5/8 with a 5/8 7degree dovetail cutter
centerd the board and set the cutter height to just above the height of the board tail cuts seem to be ok using backing board no tearout.
Now to the tails.... cut the same way as pins without alter cutter height the place board flat onto table and using stop limit the length of cut.
Prob being the tails are far to large to fit the pins tried several different cutter/heights same results Bought my LS brand new before the DVD offer was available trying to locate on in the UK any tips walkthroughs or Valium would be gratefully recieved
Cheers from a confused Taffy

Lofty

With Incra's through dovetails there is only one stock thickness for any joint. The DVD shows this, Roger at www.woodworkersworkshop.co.uk should hve the DVD's available, if not, we have them as a 'spare part'

Regards

Grahame