I want to make another thread becuase I was sure if anyone would go back and take a second look. I'm excited that it worked out.


I have a INCRA 17 inch and yes I have a manual, trouble is sometimes I have to read it over and over until I can get my head around it.

In this case I just couldn't find it. Finally I sat down with the manual and read it carefully and there it was on the last page (14 and 15) under the heading ADJUSTMENTS It said "adjusting the clamping pressure"

I loosened the Allen screw and pulled out what looked like a small white paper like shim about square about 1x1.

The kit comes with a couple of shims just for this. Package L-22 says clamping shims. Never saw it I swear.

Well I didn't know for sure if it needed to add shims or If I needed to take some out, so I removed the white shim that was in there, put it back together an wal la ! It works like a champ now. It said it was factory set when I got it but mine must have slipped by.

Hope this helps if someone else encounter it.

Good for you hexhead

Good for Hex!

Gary

thanks Gary I needed that.