Thread: 415V to 240V (15AMP)

Its extremely difficult to answer your question as it depends on how it is already wired what size cable it is etc
I assume its not wired 415v (unless its some large industrial unit) its wire 2 Phase.
One 240v Phase supplying the oven
One 240v Phase supplying the HOB (Hotplates)
If this is the case it would depend on the cable size and how its run.
I may be just a matter of terminating one phase at both ends and connecting the other to the new oven
But as I said its pointless suggesting things site unseen

Fair enough. Thanks for your thoughts.

Well I can comment (if this helps or not), the fuse box has two switches being thrown when you turn it on/off, it has joint bar.

When I moved the oven today I could see what looked like normal power cable (the white/creme coloured cable). I could only see one of them though.

Oh well , just have to wait till the electrician does the job i guess.

I always thought the second phase was for the old aircon, maybe it was just for the cooker all along.

if you have 3 phase at your house the oven is supposed to connect over two phases to share load. with most stoves ive seen it is just a matter of removing the active link at the terminal block to run on 415

Originally Posted by dan76

if you have 3 phase at your house the oven is supposed to connect over two phases to share load. with most stoves ive seen it is just a matter of removing the active link at the terminal block to run on 415

I only need the new oven to run on 240V, the old oven runs on 415V.

Oh well the sparky is booked for Thursday morning, hopefully it wont take to long as i need to get to work in the morning.

Originally Posted by dan76

it is just a matter of removing the active link at the terminal block to run on 415

It still is 240V by 2 not 415v
Anyway the new unit is combined gas stove/electric oven

It's hard to comment site unseen but if it's only 15A then it will probably just be a case of some work in the switchboard and at the oven with no new cable required. I did say probably though as it depends on the cable size.

i see your point nev, but if the two cables are different phases then its 415v, regardless of how its being used and i assume hes not on a swer line to get 480v.

If the OP already has 2 phases at the point of his stove connection, all he would need to do is to run a single "double insulated" neutral to this same connection point. This would allow him to use one phase & the neutral to give him his required 240 volts to the stove. Of course, this is subject to the wire size of the existing cables (phases).

Originally Posted by dan76

but if the two cables are different phases then its 415v, regardless of how its being used

Depends how they are wired
Phase to neutral 240v
Phase to Phase 415v