Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Expanding chuck for ryobi thread
-
17th July 2010, 02:56 PM #1Intermediate Member
- Join Date
- Dec 2005
- Location
- pambula
- Posts
- 30
Expanding chuck for ryobi thread
I have just been given a small Ryobi 10030 wood lathe and would like to buy a small expanding chuck for it. I cannot work out the thread size and on some of the websites I look at I have no idea what to buy. I am a complete beginner and would like to turn some small bowls maybe. Any help would be appreciated.
-
17th July 2010 02:56 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
17th July 2010, 03:12 PM #2Banned
- Join Date
- Jun 2007
- Location
- Otautahi , Te Wa'hi Pounamu ( The Mainland) , NZ
- Age
- 69
- Posts
- 2,114
Gilbo , check out this page , it may help you figure out the thread size for the insert
http://www.teknatool.com/products/Ch...e%20Thread.pdf
-
17th July 2010, 04:40 PM #3Deceased
- Join Date
- Jun 2003
- Location
- ...
- Posts
- 7,955
-
17th July 2010, 05:56 PM #4
Most ryobi lathes were 3/4" x 10tpi.
But if in doubt do as peter suggest and take the faceplate to a bolt store to confirm.Jim Carroll
One Good Turn Deserves Another. CWS, Vicmarc, Robert Sorby, Woodcut, Tormek, Woodfast
Are you a registered member? Why not? click here to register. It's free and only takes 37 seconds!
Similar Threads
-
Set up for chuck expanding mode
By Tiger in forum WOODTURNING - GENERALReplies: 16Last Post: 13th May 2010, 11:23 AM -
Leadbetter expanding chuck
By Rod_G in forum WOODTURNING - GENERALReplies: 9Last Post: 3rd June 2009, 09:33 PM -
spindle thread for chuck
By RedRush in forum WOODTURNING - GENERALReplies: 3Last Post: 23rd March 2009, 10:20 PM -
Bonham Chuck thread size
By maxwellavizla in forum WOODTURNING - GENERALReplies: 1Last Post: 1st March 2008, 09:08 AM -
Expanding foam
By ozwinner in forum NOTHING AT ALL TO DO WITH WOODWORKReplies: 21Last Post: 28th July 2004, 09:23 PM