Thread: Help - Changing Drive Belt on a Carba Tec mini lathe

There should be a grub screw on the external shiny round handle/knob and one on the pulley.
Remove those and then pull the handle off and knock the spindle through the pulley with a wooden hammer

Bob is right on the money I have just done the exact same lathe and simple to do.
Regards Rod.

Thanks gents, but I tried removing grub screws and still couldn't budge the chrome hand wheel from the shaft. Did a little more research on the forum and Youtube and found that there are circlips on the inside edges of the bearings holding the shaft in place and the hand wheel is screwed onto the shaft rather than a press fit (explains why I could not punch the shaft through the hand wheel with a dead fall hammer and increasingly heavy blows and lots of swearing). To further complicate matters the hand wheel is also screwed on with a left hand thread rather than the standard.
IMG20170319130841.jpgIMG20170319130923.jpg
It seems that there must be many variations on the base design as the extra information I found didn't relate directly to the Carba Tec 1018 but to a look-a-like with a different trade name (Central Machinery 65345) - bit of a trap for unwary players
Now all I have to do is find a supplier for a quality replacement belt