Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 18 of 18
Thread: Hollowers
-
15th August 2017, 09:03 PM #16
Smiife, the swan neck can get into gentle corners on tight apertures or on more generous openings I have been able to have 90°corners. 50mm allows such angles. There is a true swan neck available, but I have not yet bothered to get it.
The red one is a woodcut swan neck, in a Kelton handle.Pat
Work is a necessary evil to be avoided. Mark Twain
-
15th August 2017 09:03 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
15th August 2017, 09:19 PM #17
My hollower. Tape open to 900mm
P_20170815_200926_1_p[1].jpgP_20170815_201345_1_p[1].jpg
-
16th August 2017, 05:43 AM #18
Heres the set I made for the Ultima. It has a slightly longer link on the cutter than what Sorby provide and the handle is foam covered. The shaft will slide inside the handle to vary the length. Nothing too flash its an older handle and shaft from way back. But the shaft is good 20mm dia high tensile hard chromed. It's an old pneumatic cylinder rod and is much stiffer than most.
Inspiration exists, but it has to find you working. — Pablo Picasso
Similar Threads
-
Kelton bowl saver (corer) and deep hollowers FS - FYI
By rsser in forum WOODTURNING - GENERALReplies: 0Last Post: 27th January 2013, 08:34 PM -
a compendium of hollowers
By hughie in forum WOODTURNING - GENERALReplies: 6Last Post: 24th November 2010, 11:39 PM