Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 7 of 7
Thread: Jet Mini Spindle
-
19th January 2008, 11:01 PM #1
Jet Mini Spindle
My Jet mini has a 1" x 10tpi spindle. Does anyone know if the threadform is UNF?
ThanksChris
========================================
Life isn't always fair
....................but it's better than the alternative.
-
19th January 2008 11:01 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
19th January 2008, 11:28 PM #2
well after looking around I'd say it's not UNF or UNC. But I know didley....
EDIoT: 1 x 10tpi = UNS
-
20th January 2008, 08:22 AM #3
Whitworth thread if I'm not mistaken
-
20th January 2008, 01:25 PM #4Woodturner
- Join Date
- Jan 2006
- Location
- Lake Seminole, Georgia USA
- Age
- 79
- Posts
- 1,111
Chris,
It is "probably" 1" x 10 tpi BSF RH (British Standard Fine, Right Hand).
UNC, UNF and Metric Threads are a 60° angle
Whitworth, BSW, BSF are a 55° angle.
Check out this Teknatool page, lots of good thread data there.
http://www.teknatool.com/support/How...e%20thread.htm
-- Wood Listener--
-
20th January 2008, 04:04 PM #5
-
20th January 2008, 04:12 PM #6
Thanks Gil,
I went trawling the thread charts again, and I think you're probably right. Found a useful site with thread info hereChris
========================================
Life isn't always fair
....................but it's better than the alternative.
-
21st January 2008, 11:20 AM #7Member
- Join Date
- Dec 2006
- Location
- S.Australia
- Posts
- 55
Similar Threads
-
Spindle Sander
By les88 in forum GENERAL & SMALL MACHINERYReplies: 18Last Post: 17th June 2008, 12:29 PM -
CNC Router with DC Spindle
By rodm in forum CNC MachinesReplies: 23Last Post: 20th October 2006, 08:19 PM -
Jet mini versus Leda mini
By bloggs1968 in forum WOODTURNING - GENERALReplies: 18Last Post: 15th August 2006, 10:03 PM -
CT Spindle Moulders
By ltovey in forum JOINTERS, MOULDERS, THICKNESSERS, ETCReplies: 12Last Post: 12th May 2005, 12:00 PM -
Spindle Thread
By antman in forum WOODTURNING - GENERALReplies: 2Last Post: 20th September 2003, 04:45 PM