Thanks: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
-
7th April 2019, 11:27 PM #1
offset turning, assistance required
Good Evening Ladies and Gentlemen
I am in the process of making axe handles, bot cross cut and block splitter.
I have carved a few handles, happy with the process they turned out well. Made from Wandoo.
Now I want to turn a handle for a block splitter, they are oval.
The hole to accept the handle is 33 x 37mm.
I have turned the handle round to dry.
Now, how many mm do need to offset the turning to achieve an oval handle??
Thanks
Willy
-
7th April 2019 11:27 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
8th April 2019, 06:58 AM #2GOLD MEMBER
- Join Date
- Sep 2008
- Location
- North Carolina, USA
- Posts
- 2,327
I would offset 2mm off center one direction and turn , then 2mm off center the opposite direction and turn. You will probably have to go back to the original center and sand while rotating to get any ridges off where you grip. Also some sanding & carving to fit the hole.
I like to sand the hole in the tool with 50 - 80 grit to get some tooth on the metal, grease up the hole and handle with epoxy put the handle with saw slit in hole, drive in wedge, and then pour epoxy into any voids. Put tape on the bottom side to keep epoxy from running out.
When you break off the handle it is a real pain to get everything out of the hole in the tool.So much timber, so little time.
Paul
-
8th April 2019, 07:47 AM #3
I’d draw the required oval shape full size and measure the curvature of the long sides using paper radius gauges. You might find that the long faces need quite a large offset to match the curve and you’ll probably need to shave down the smaller faces by hand to fair everything in.
Nothing succeeds like a budgie without a beak.
Similar Threads
-
Offset turning
By MWF FEED in forum METALWORK FORUMReplies: 0Last Post: 18th March 2019, 03:20 PM -
Assistance required please
By Allan at Wallan in forum TIMBERReplies: 2Last Post: 10th November 2016, 11:23 AM -
Offset turning query
By cultana in forum WOODTURNING - GENERALReplies: 10Last Post: 30th March 2010, 12:33 PM -
Assistance Required
By Cantswingahamer in forum HAND TOOLS - POWEREDReplies: 4Last Post: 24th February 2009, 08:50 PM -
Offset turning
By macca2 in forum WOODTURNING - GENERALReplies: 5Last Post: 4th July 2004, 11:08 PM