Thread: My first turned pieces

nice job better than my firsts.

that stringy bark can be a bit of a dasturd got chipping out and is fairly hard to sand but you have done a mighty good job on it.

Excellent results, Ashes. The inside of bowls can be a PITA to cut without ripples. Well done.

The MC900 gets some unfavourable virtual ink, but I wouldn't sell it short. Top of the line at the lower end, IMHO. My Harbor Freight 34706 is substantially identical, and it's serving me well after about two years. I haven't yet installed the spare belt I got in August 2006. I assume the MC900 also has the auxiliary elbow tool rest for outboard turning; if it doesn't break when/if I first try outboard turning, it'll be because I've been too timid. A free-standing outboard rest, or more robust attachment to the lathe, would be nice to have in reserve.

Joe

Yep, well done. If can keep the learning curve going at this speed it wont belong before an old hand at it






Joe your right about the banjo on the MC series I had to modify mine...woeful comes to mind as a word to describe it

Ashes well done it wont belong before your a pro

Originally Posted by Ashes

...........I thoroughly enjoyed turning these............

Great start Ashes Welcome to the addiction - there's no 'turning' back now!

Samdpaper is one of those things that goes away little by little as you learn more how to use the tool, the biggest thing is that it is kept very sharp, if you become lazy and say well ill do this one then sharpen, you will not do so good. keep um sharp and the grade of paper and use diminishes. The biggest thing is to enjoy, look at sites and turnings, look at pottery glassware look at shapes and play with designs, if you start something then become unsure, leave it start something els come back to it. Keep the fun going, the interest gets bigger the pockets wallet get smaller its amazing what you get for your money though, you buy a small blank to make a vase and walk out with a big bin liner full of shavings how does that wood get so big I have seen a lot of first turnings and yours are not bad at all. enjoy the fun LB

Great work Ashes!
Now the fun really begins!

Isn't the first turnings spose to be out of Cra.... I mean Radiata pine? Using nice wood is cheating. No. I'm just jealous. Will have my own lathe one day. Well done Ashes.

nice job Ashes

You have done yourself proud.

Nice work mate

Yep, beats my first efforts by a country mile. Well done.

TL raises the issue of 'learning' timber. My take on this is that there are a number of timbers that turn well and so you don't get discouraged early by tear-out, tool control troubles and generally crappy results. IMO, they're worth spending money on.

Out your way TL, if you haven't already, pop down to The Woodsmith and get advice from Len or Phil. I've always found them generous with their time, and have never had a dud blank from them.

Ditto for Rowie in Coburg - but you've been there already.