Results 16 to 21 of 21
Thread: Power sanding your bowls?
-
22nd August 2018, 06:37 AM #16
I do use both. Mostly an inertia sander but if I have a problem area, a drill as a power sander carefully over that area.
The issue I have with power sanding is electric drills only have a life of around 100 hours, that's forever drilling holes but constant use as a sanding device chews through that time very quickly.Dragonfly
No-one suspects the dragonfly!
-
22nd August 2018 06:37 AM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Age
- 2010
- Posts
- Many
-
22nd August 2018, 03:38 PM #17
Neil, sorry for the slow rate of reply, life has got in the way.
The set up is a simple affair attached to a small bed at 90' to the main bed at the Headstock. It can swivel on the base or on the cross-coupling at the top/above. Currently, thats where it swings with a collar underneath to maintain height setting. Also, the horizontal arm can move in and out to vary the arm length as needed. Then to all this the drill and flexible drive is fitted.Inspiration exists, but it has to find you working. — Pablo Picasso
-
22nd August 2018, 03:46 PM #18
I must be lucky as I bought a very cheap Chinese variable speed hammer drill 13mm capacity several years ago and it last about 5years and it was my go to sander during those years. Its longevity amazed me as I was busy on the lathe 15-20 hrs a week. The failure was a worn out plastic bearing housing, everything else was running ok. Unfortunately, the housing was part of the main body and not practical to repair.
Inspiration exists, but it has to find you working. — Pablo Picasso
-
24th August 2018, 01:23 AM #19
-
24th August 2018, 06:00 PM #20
-
25th August 2018, 02:22 AM #21
Similar Threads
-
Power Sanding: Not Sure I'm Buying It
By Luke Maddux in forum WOODTURNING - GENERALReplies: 12Last Post: 26th May 2015, 10:43 PM -
Best speed for power sanding
By Sturdee in forum WOODTURNING - GENERALReplies: 24Last Post: 7th June 2010, 09:56 PM -
Sanding the inside of bowls
By ElizaLeahy in forum WOODTURNING - GENERALReplies: 33Last Post: 22nd July 2009, 10:58 PM -
Minimising sanding on bowls etc
By rsser in forum WOODTURNING - GENERALReplies: 23Last Post: 3rd July 2007, 09:24 PM -
Sanding bowls
By Charles Castle in forum FINISHINGReplies: 4Last Post: 18th September 2005, 08:50 PM