Thread: Making A Yarn Bowl

Originally Posted by Paul39

How wide should the spiral slot be?

Only wide enough to slide the yarn through the slot. Most yarn will compress, so will fit in a narrower slot than its normal width. Wider won’t matter, but a smooth surface in the slot does. Any roughness in the slot will snag the yarn.

I have made them for my daughter-in-law with a lid and a spiral that runs to the centre top. That design works well for feeding from the centre of the yarn ball.


Stay sharp!

Neil

Originally Posted by NeilS

I have made them for my daughter-in-law with a lid and a spiral that runs to the centre top. That design works well for feeding from the centre of the yarn ball.

Here is an example of that design.

IMG_20170207_150914.jpg

The wood is a bit ordinary looking (Paulownia), but was selected for its lightness. My daughter-in-law uses it when she is travelling.


Stay sharp!

Neil

Guys
youve got me intrigued. My grand Ma would love one of these.

how do you do the spiral ?

Randal

Originally Posted by Goggomobile

.

how do you do the spiral ?

Randal

I do mine with a fretsaw, then sandpaper to smooth.

Stay sharp!

Neil

@Ilya would be a good one to contact about these. He has made quite a few and they are very good.

No doubt he has many tips and tricks

A knitter friend suggested that if the slot is in the side of the bowl, unlike Neil's, then you need to have the base wide and heavy to keep it stable.
I'm on notice to make a couple.