Thread: Pine Panelling -Help what is it.

pants, pine panelling/pine lining is (here anyway - where the BH is Sandgat4e?) 140x12 t&g run of mill pine, often has VJ pattern on one side & regency on other. Knotty & cheap & cheerful.

I'd reckon the knots would show through paint.


Cheers..................Sean

Hi pantotango,

I'll assume you're in Sandgate near Newcastle. Is that correct?

Pine tongue & groove panelling is fairly common. Most timber places would have it I reckon. In fact, I'd be surprised if Bunnings didn't have it.

have used t&g pine a lot large bedroom and some other rms as well the bedroom was all second hand wood needed all the old nail holes filled etc but as it was painted came up fine and the knot holes didnt show up much at all still looking ok 2 yrs down the track

also found it was pretty cheap as was very little wastage as was able to join short pieces together as long as i remenbered which angle i had cut the boards at

what about doing a 1/2 wall with the wood and then daddo line about room and rest with plaster board above ? might work out cheaper and still have that old world look

when i re do rest off hse here will look at doing all the rms out with the boards thats when i can afford to get rid of the fibro thats on the walls inside and out at the monent

hi pantotaongo

where I get my supplies from pine panelling is about $1.75 per lineal metre for 133mm cover which means it will cost you about $13.15 per square metre.
mdf vj sheeting will cost about $45 for a 1200 x 2400 sheet, about $15.60 per square metre.
IMHO I don't think the panelling looks the part as it has a V joint down the centre of it making it look like 66 mm VJ's (too narrow) the VJ sheeting has 101mm V joints, goes up much quicker and takes paint better.
You should get a better price than above if you are buying a large quantity.
You could go with proper VJ's but that will cost you about $60 a square metre .
Is that sandgate Queensland or sandgate NSW

Sangdgate in Brisbane on the Northside.
Ill pop into Bunnings today and see what they have and also try the timber mill in Sandgate.
Thanks so much for all the help
Im sure Ill have plenty more questions to come as we slowly get through the performance of building this thing.

Hi - if you are in a queenslander I recommend you consider Regency style lining boards instead of VJ. I think they are more attractive than VJ and are the same price - BTW if you are going to paint them, R.O.M. is an excellent choice, as the imperfections can be filled - if you intend clear-lacquering or staining them, think carefully as the look dates very quickly and the finish can yellow significantly (at least it did back in the 80's when all and sundry were pine lining their homes - me too......what was I thinking!!!???)

it is unfortunate that this country doesn't offer many other alternative profiles for lining boards. When we extend (okay, 'if') I will be running my own profile, a 60mm small regency bead lining board, as seen in just about every period home renovation in the USA. It is great as panel infills on cabinet doors too as well as splashbacks, when correctly sealed. I will hunt down a pic and Post it in a minute in case anyone is interested to see it

Above all - have fun

this link gives some idea what the finished result looks like

http://j.b5z.net/i/u/2051850/i/DSCF0878.JPG

This is a piccie of the pine panelling with the Regency bead done part way up the wall with gyprock the rest of the way up.
Hope the piccie helps.
Carry Pine

FYI - I believe the image above is of 140mm X 12mm Radiata ..... available extensively.

have fun!