Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Finger joints / box joints
-
21st May 2014, 08:13 PM #1Novice
- Join Date
- May 2014
- Location
- Tasmania
- Posts
- 17
Finger joints / box joints
If your box dimension is say 240 x 340 and the timber is 19mm thick, do you add the thickness of the timber to each end of the piece you are going to cut to maintain your dimensions???
-
21st May 2014 08:13 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
22nd May 2014, 10:18 AM #2GOLD MEMBER
- Join Date
- Sep 2011
- Location
- Valla Beach
- Posts
- 1,190
I would imagine you leave your four pieces of timber cut at 240 and 340. To give you your outside measurements as you said. Your internal measurements would of course then be 202x302.
Paul
-
22nd May 2014, 08:34 PM #3
Or maybe the dimensions you quoted were intended to be internal (you didn't specify), in which case you would allow a smidge over the wall thickness at each end to maintain your required internal dimensions. The smidge extra is to allow the joint pins to be slightly proud when glued up, so there is material available to sand flush and smooth on completion.
I used to be an engineer, I'm not an engineer any more, but on the really good days I can remember when I was.
Similar Threads
-
finger joints
By cvr_30 in forum BOX MAKINGReplies: 1Last Post: 11th May 2009, 05:41 PM -
finger joints
By meso in forum TRITON / GMCReplies: 6Last Post: 20th September 2006, 11:48 PM -
Finger joints
By Fed in forum TRITON / GMCReplies: 3Last Post: 1st April 2004, 12:16 AM -
Finger (Box) Joints
By Woodchuck in forum ROUTING FORUMReplies: 2Last Post: 17th February 2004, 11:24 PM -
Finger Joints
By Chippie in forum TRITON / GMCReplies: 4Last Post: 11th January 2004, 09:36 PM