Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Abrasive to Rub Back Shellac
-
2nd January 2018, 07:50 PM #1
Abrasive to Rub Back Shellac
I have put down about 10 coats of 1/4 pound cut of shellac as a sanding sealer.
I used Tripoli powder as a grain filler on red oak. It has been curing for a week now.
I am now looking to rub it back to remove any imperfections in the base coat.
My research says that Tripoli powder is about #1200 grit. Is this True?
I am looking at 3M™ Aluminum Oxide Films 3µ (about 4000x) & the 1µ (8000x)
Or should I use something else? like Superfine Rubbing Pad, per foot 3M™ Rubbing Pads
I then plan to build up the body and then rub back again and finally finish with conservators wax.
-
2nd January 2018 07:50 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
3rd January 2018, 01:59 PM #2GOLD MEMBER
- Join Date
- Jun 2014
- Location
- Seattle, Washington, USA
- Posts
- 1,857
It's been my experience that polishing shellac smooths it out to a glassy surface without the need for super fine abrasives. I just use 320 or 400 grit. Whatever the final sanding I use on the wood is.
But that's French Polishing... Maybe you're trying to achieve something different?
Cheers,
Luke
-
12th January 2018, 06:45 AM #3
Sorry for the late response. Have a look at our updated Tripoli information, only uploaded at 6:30 this morning
http://www.ubeaut.com.au/pdf/no4.pdf
Cheers - NeilKEEP A LID ON THE GARBAGE... Report spam, scams, and inappropriate posts, PMs and Blogs.
Use the Report icon at the bottom of all Posts, PM's and Blog entries.
-
12th January 2018, 01:15 PM #4
Neil thanks for the info. Luke it has also been my experience that 400 grit does give a very smooth surface. However I was wondering if I could improve my finish. Because Lee Valley sells the super fine grits claiming them for French polishing. I will have a go at the 1200 grit range and see if it is any better then the 400.
-
13th January 2018, 10:25 AM #5Intermediate Member
- Join Date
- Aug 2017
- Location
- Moggs creek
- Age
- 59
- Posts
- 47
I use wet and dry and work my way up through the grits from 600 ,800, 1200, 1500, 2000, 2500, then use a buffing compound to get a mirror finish.
Similar Threads
-
Abrasive cut off blade
By lukejj in forum METALWORK FORUMReplies: 2Last Post: 26th May 2010, 09:03 PM -
abrasive cloth
By Big Mac in forum FINISHINGReplies: 1Last Post: 19th January 2006, 03:52 PM -
Using sand as abrasive
By JB in forum FINISHINGReplies: 16Last Post: 8th December 2005, 02:47 PM