How to resaw safely on the tablesaw?
The blade on my table saw projects 65mm above the table, and using a thin rip blade with 3mm kerf, I want to safely and neatly resaw 120mm boards on the table saw.
I tried it freehand, with a push stick and with a featherboard holding the material against the fence up to the start of the sawblade, and invariably the saw blade chewed into one side towards the end of the pass where I was unable to keep both pieces perfectly upright. I felt the situation was not under control and possibly dangerous and decided not to do it again until I knew how to do it properly.
Can anyone please suggest a proper method of doing this procedure by hand, if that is possible, or suggest some ideas for a jig that will do this safely and perfectly every time?