Search:
Type: Posts; User: Tyger
Search: Search took 0.00 seconds.
-
20th August 2018, 06:49 PM
Thread: Veneer Tape
by Tyger- Replies
- 1
- Views
- 4,132
Veneer Tape
I'm looking for a supplier of 19mm, no-hole, white veneer tape. I've contacted Veneer Craft (an on-line store) as I've heard they have it but so far no reply after almost 2 weeks. If anyone knows...
-
Thanks to all. Cheers Peter.
Thanks to all.
Cheers
Peter. -
Dividers
I am in the process of making a watch box for my son, about 210 x 297 mm. Thickness of the sides are 12mm. I want to have 6 compartments with pillows for the watches. I want to make the lining and...
-
3rd June 2015, 04:25 PM
Thread: Tormek problems
by Tyger- Replies
- 7
- Views
- 2,224
Good thing I'm stubborn. Thanks to all. Looks...
Good thing I'm stubborn. Thanks to all. Looks like I'll just fiddle about with it until T-7 and I come to a mutually agreeable outcome.
Cheers -
3rd June 2015, 02:08 PM
Thread: Tormek problems
by Tyger- Replies
- 7
- Views
- 2,224
The blade is sitting square to the sides of the...
The blade is sitting square to the sides of the jig both front and back and I'm using only a light pressure on the blade to the stone. I just tried again with an old blade. I used a permanent...
-
3rd June 2015, 09:30 AM
Thread: Tormek problems
by Tyger- Replies
- 7
- Views
- 2,224
Tormek problems
I did, but it still didn't grind square to the side of the plane blade. How much of the blade should protrude from the jig? Perhaps I have too much which would make the post higher and causing the...
-
3rd June 2015, 08:01 AM
Thread: Tormek problems
by Tyger- Replies
- 7
- Views
- 2,224
Tormek problems
Hi all,
I got a Tormek T7 a few months ago and I finally got to give it a test run and I have to say I'm a bit disappointed with how square it grinds plane blades. I thought the SE-76 jig was...