Search:

Gabbett machinery were on Juna Dr Malaga. According to yellow pages their contact phone is 0862505400

I doubt you could fit the saw in a van as it weighs about 600kg (maybe more). If the fence is...

Hi SiRo,
i ended up getting my machine serviced by Gabbets in Malaga and i cannot speak highly enough of them. The cost was reasonable (about $300 i recall) and they also helped me out with a few...

Thanks Albert,

I'm not yet at the stage where I make any income however this would be a bonus. I do take your point though that time spent fixing machines is time not spent making stuff....

Hi everyone,
I just bought an old SCM SI15F panel saw. Its had lots of use but is built like a tank and I am confident that with a little TLC I can get it going like new (well as close as possible)....

Thanks folks,

If only I had read your comments before I used the screws. Oh well - lesson learnt. I will try and extract the shanks on the weekend which might be challenging. Drilling out 10...

Hi folks,

Just thought I would have a whinge following a product failure on the weekend. Was putting the final parts together of a chair I have been working with for a few months and foolishly...

Thanks Boban,

Will be speaking more to the sparky after he has done his sums. I am hoping to do the leg work too so your figure might be right. The location is prone to rock so this could...

Thanks for the feedback and advice everyone,

I have been speaking further to the electrician about either using single phase machines or possibly trying a phase converter. However, it seems that...

Hi experts,

We are about to move to a new house and I have just discovered that 3phase power is not available. This is a bit of a problem since I have a shed full of 3phase machines that I was...