Search:
Type: Posts; User: Nielsen
Search: Search took 0.00 seconds.
-
15th May 2019, 04:45 PM
- Replies
- 6
- Views
- 4,234
Gabbett machinery were on Juna Dr Malaga....
Gabbett machinery were on Juna Dr Malaga. According to yellow pages their contact phone is 0862505400
I doubt you could fit the saw in a van as it weighs about 600kg (maybe more). If the fence is... -
15th May 2019, 11:24 AM
- Replies
- 6
- Views
- 4,234
Hi SiRo, i ended up getting my machine serviced...
Hi SiRo,
i ended up getting my machine serviced by Gabbets in Malaga and i cannot speak highly enough of them. The cost was reasonable (about $300 i recall) and they also helped me out with a few... -
6th November 2014, 04:14 PM
- Replies
- 6
- Views
- 4,234
Thanks Albert, I'm not yet at the stage where...
Thanks Albert,
I'm not yet at the stage where I make any income however this would be a bonus. I do take your point though that time spent fixing machines is time not spent making stuff.... -
5th November 2014, 11:00 PM
- Replies
- 6
- Views
- 4,234
Advice wanted on servicing an SCM SI15F panel saw
Hi everyone,
I just bought an old SCM SI15F panel saw. Its had lots of use but is built like a tank and I am confident that with a little TLC I can get it going like new (well as close as possible).... -
2nd July 2010, 12:49 AM
Thread: Zenith screws!
by Nielsen- Replies
- 14
- Views
- 7,609
Zenith Screws
Thanks folks,
If only I had read your comments before I used the screws. Oh well - lesson learnt. I will try and extract the shanks on the weekend which might be challenging. Drilling out 10... -
28th June 2010, 11:27 PM
Thread: Zenith screws!
by Nielsen- Replies
- 14
- Views
- 7,609
Zenith screws!
Hi folks,
Just thought I would have a whinge following a product failure on the weekend. Was putting the final parts together of a chair I have been working with for a few months and foolishly... -
9th June 2009, 09:30 PM
- Replies
- 15
- Views
- 9,861
Thanks Boban, Will be speaking more to the...
Thanks Boban,
Will be speaking more to the sparky after he has done his sums. I am hoping to do the leg work too so your figure might be right. The location is prone to rock so this could... -
9th June 2009, 12:58 AM
- Replies
- 15
- Views
- 9,861
Thanks for the feedback and advice everyone, ...
Thanks for the feedback and advice everyone,
I have been speaking further to the electrician about either using single phase machines or possibly trying a phase converter. However, it seems that... -
6th June 2009, 08:36 PM
- Replies
- 15
- Views
- 9,861
Advice re: Converting 3phase to single phase
Hi experts,
We are about to move to a new house and I have just discovered that 3phase power is not available. This is a bit of a problem since I have a shed full of 3phase machines that I was...