Search:

https://www.amazon.com/Replacement-Belt-Nova-3000-1624-44/dp/B003FHQPXQ
hope this helps.

https://www.ebay.com.au/itm/Tungsten-Steel-Alloy-6-20mm-Blade-Ball-Router-Cutter-Bit-Carving-Engraving-Knife/311861347027?ssPageName=STRK%3AMEBIDX%3AIT&var=610706402405&_trksid=p2060353.m2749.l2649

The ball end bits turned up and worked well. Thanks again for the input.423237423238423239423240

yes. spot on mate. but have you tried the ball end bits?

The barrel is tapered and the owner wants a snug fit.

will do

ebay.lol. Yeah , I know. No quality but cheap!!

I think they cover themselves by saying ball end, rather than nose. They seem most popular with the 2d printer guys for carving faces etc. but they use 2 and 3mm bits. I have a 20mm bit coming!

Learning as I go!! I just figured if a round nose cuts 180 degree circle and a ball cuts 360 degrees, then it might be doable! I better do lots of tests first, when the bit arrives!

The only info I can find on these is, "Do the cut in one pass." , but the are refering to cutting a "bore hole" along a length of timber, not a gradual trench. Thankyou for your input. Always best to...

421769421770first pic is the ball end, second a round nose.

Cool. thanks. Was a toss up between a round nose or a ball end. The ball end was $3 so thought would give it a fly. Need to cut a 15mm deep groove in a 300mm long piece of timber, 20 wide one end and...

Hi. Was wondering if anyone has used a ball end router bit and if so, did they have any dramas? I am not looking to cut a pipe recess into a piece of wood, but am hoping to cut a round bottomed...

Hi I scored an xceed 254 thicknesser with a cooked motor. Had plans of mounting another motor above the original but thought would ask first. Does anyone have a motor from one that has failed in...

Check that you actually have a spark at the plug. If all good there, carbi may need a clean as the petrol would have evaporated over time and left the oil behind.

Hi. I have inherited a smoked xceed pt254 thicknesser. Had wild plans of maybe slipping a pulley onto the armature shaft and mounting a motor on top. I had noticed some old posts from people that had...

Hi. I have some blades from one of those. They have a hook in them. Need a sideways slide before they pop out.420278