Search:
Type: Posts; User: Bioman
Search: Search took 0.00 seconds.
-
15th March 2005, 12:39 AM
Thread: Looking for advise on Jointers
by Bioman- Replies
- 10
- Views
- 2,751
What I do.
One of custom work. Will be going at it full time in a few eyars, so I am gearing up. :D
-
9th March 2005, 01:49 AM
Thread: Looking for advise on Jointers
by Bioman- Replies
- 10
- Views
- 2,751
Whereas the Taiwanese and Chinese units have...
Whereas the Taiwanese and Chinese units have improved in recent years a lot, some early very bad experiences have left me with unwilling to repeat the mistakes of the past. Having said that, I...
-
9th March 2005, 01:28 AM
Thread: Looking for advise on Jointers
by Bioman- Replies
- 10
- Views
- 2,751
Thanks guys, I owned a combination unit until...
Thanks guys, I owned a combination unit until recently, a Robland X-31 ;) . I need to go the separates route at this point, as it is a better match for my current process flow. Does anyone know...
-
8th March 2005, 01:07 AM
Thread: Looking for advise on Jointers
by Bioman- Replies
- 10
- Views
- 2,751
Looking for advise on Jointers
I would like advice on what industrial jointer to buy. I am looking for a 16” width and beds that are somewhere in the 92 to 110” length. No need for helical cutters or anything fancy. I am...
-
21st October 2003, 05:50 AM
Thread: Veneer Softener
by Bioman- Replies
- 4
- Views
- 5,789
Softening
Thanks for the response gatiep. I am looking for a softener that is not water based. Most of the commercial products are polymer based. I have seen one recipe (one of Tage Frids books) that is...
-
17th October 2003, 07:51 AM
Thread: Veneer Softener
by Bioman- Replies
- 4
- Views
- 5,789
Veneer Softener
I am looking for a veneer softener I can make. I can purchase products commercially for about $25 to $30 per gallon, but wanted to see if there are any DIY formula’s anyone has had success with. Of...