Search:

Need a frig tech, he will pump the refrigerant back into the outdoor unit and seal off the valves on the outdoor unit. Then dicsconnect the indoor unit and wiring as he would have an electrical...

The SB980WK is the new unit made in Italy, looks to be a good unit. there is a recall on re the main control printed cct board.(if the unit is between xx and xx serial nos. check the electrolux webb...

the motors are transistor driven from the indoor pcb, not available and you cant substitute tthe motor. Nor can you mix and match indoor and outdoor units. cheapest option is to go to local hardware...

Hi, the capacitor is there for a phase shift between the 2 windings in the motor. you can easily get a capacitor at any appliance repair place that is the same as the original. going too far from the...

I cut my blanks in half and mark then with a texta so i can always get the grain matched. Then only drill a half the pen at a time. The blanks are clamped in a jig to ensure no movement. Works a...

I have a lot to check for with all your ideas. Will review my methods and check with the magnification, might give me some answers.
No I don't normally have any problems with other wood, but that...

It's standing by the front door "in the lounge room" nick named the Great Dane, my wife even stuck a tail on it.:roll:

Hi, when I get near the thinest part near the bush I get tearing out of small lumps. I have tried different lathe speeds and very soft cuts but no success. I know this is a very soft timber but the...

[QUOTE=jimj;496136]Sorry for the dumb question and this may have already

You can get a kit for removig scratches of of CD's this works well as it is a two part application, I think the first part...

Removed 4 screws from bottom, seperated top and bottom.found 1 small fan motor and 2 batteries. Problem was where wire was soldered on to the terminal of the fan motor, wire had broken off, (wire is...

I have 2 adult refrig lads going thru trade school at the moment, they have log books and need them signed off, some of the work they are required to do we dont do so they are sent off to another...

DPB where did you get the "hand crafted by Don Barton " emblems.
I have serched high and low to find out where?
Gyro

Hi, looks like no one wanted to reply so will try to help as i have had considerable experience with these. (ISOLATE THE UNIT) turn off the power at the meter box and check the unit wont work,, 1st...

If the doors are external then check your insurance policy, mine had to be deadlocks. Which was not easy as the doors were too thin so new doors for me unfortunately.

A friend of mine did this and all their plants had stunted growth, they eventually gave up on it and now they have had to remove the soil and get in fresh soil and plants.

Hi,
I have made two of the Dick Smith/Silicon chip speed controls, I use one for a large buff for polishing the car which had a speed control but lasted a day so i bypassed it and now use the one i...

thanks for that, I will now paint it orange and try to find the instruction book.

If anyone has a powered hat could they tell me the voltage on the 240v charger. I have so many im not sure which one to use. I must tag it.

thanks.
gyro

I had a van with a yellow stripe around it and never again, some days you could not get near it for the bee's

So is your shed clean?
pigs could live in mine! :)

Thanks guys n galls,
Found a book "Building Antique Model Cars in wood"
isbn 1-895569-51-6 Local library had it and have ordered one for myself.
check it out if you are interested in old model...

Thank you, looks interesting

Any ideas on where I can get info on building model wooden spoked wheels.
I once saw an article on it and cant remember where i saw it.