Search:

Thank s for that info I was understood that Jet came from Germany. Certainly would be cheaper to fit stronger hardware. appreciate your comment. jh

all fixed up the adjusting bolt on the tracking was damaged, cheap chinese will be selling this bs and looking at a Jet for quality My thanks to everyone who came to my aid

Likewise my table was way out of alinement on delivery and on dismantling the tracking works today, they are pretty worn, if fact they are rubbish. Will be getting some stronger bolts to refit. I...

Yes, everything gets tighten after an alteration, tomorrow i shall strip it down and check if the two wheels are in enliinement, has been suggested that when assembled the tracking mechanism may be...

No changes except for realigning the guides when i swopped to smaller blade and perhaps a small twinge of the top wheel.
spoke to mach8nery warehouse this afternoon, they suggest pulling the top...

The bs is two years old and the tyres on both wheels are good. I changed from a 1/2inch blade to a 1/4 around January this year and then it started, since then i have gone through three 1/4 blades...

I have a Halco Waoodmaster 355 bandsaw about two years old, I am not able to get blade to run true, the blade will sit perfectly on the top wheel (centre of tyre) but then the blade sits on the rim...

The bandsaw is just ok but if you want refinement this isn’t the machine. I have had to replace the wheel adjustment with a stronger bolt and nut as this is the way the wheel is adjusted. It is...

I appreciate all you woodies comment to my problem, thank you. I will try each one over the weekend and hopefully solve my problem.

I recently purchased a new Hafco Woodmaster bandsaw it continually tracks to the left. I have centred the guides, centred the blade on the wheel and tensioned the blade as per manual. But it still...

Thank you you have explained just what i wanted to know without going round in circles, now the $64 dollar question what is the preferred buy among everyone. This evening I have been looking a de...

Up till now I have been working mainly on the lathe doing bowl and goblet work. After a fun challenge given to me by a lady (naturally) I have made her a writing bench out of real scrap wood. i am...

Thanks bob for your reply, I had already tried Bunnings but they told me they did not stock them, Asked again this morning and guess what they have four on the shelf, My new motto will be always ask...

http://d1r5wj36adg1sk.cloudfront.net/images/smilies/smile.gif

i purchased a Ryobi router ERT 2100VK from a clearing sale it has only the 1/2 inch collet, my question has any one got a 1/4inch they would be willing to sell to me. Ryobi tell me they no longer...

[QUOTE=BobL;1810297]Hi John, Firstly welcome to the forum.

It won't make any difference what size motor you use on those small DCs.

It's not the motor that is a problem, it spins at 2850RPM...

i purchased a 1hp dust extractor from Carba Tec without knowing the fall off of suction once you place a bend and concertina hose in the system. Is it possible to replace the 1hp motor with...