Search:
Type: Posts; User: Alastair
Search: Search took 0.01 seconds.
-
14th June 2011, 11:30 AM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
Another suggestion, (which I was planning to use...
Another suggestion, (which I was planning to use to do the additional holes for holding sheet stuff), is plunge router, and up-spiral bit.
regards -
9th May 2011, 01:02 PM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
FWIW Groggy, After going to great lengths to...
FWIW Groggy,
After going to great lengths to perfect the end-grain finish on my dovetails, I have found that with the massive swings in humidity we have had in Sydney over the last year or so, it... -
21st December 2010, 05:22 PM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
Reckon so, My Mrs had plantar fasciatis,...
Reckon so,
My Mrs had plantar fasciatis, which is "tennis elbow" in the sole of the foot.
Nothing really worked, rest/excercise/orthotics.........eventually she had a cortisone shot into the... -
20th December 2010, 10:44 AM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
Called "old age" I think I remember?:D I'm in...
Called "old age" I think I remember?:D
I'm in a similar state............ shoulder which flared up after pressure cleaning outside walls, and has persisted through grouting, plastering, planing,... -
26th October 2010, 03:27 PM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
Hi Groggy, Mine would probably qualify as...
Hi Groggy,
Mine would probably qualify as "agricultural"! You can see them in my bench thread from 2 years ago. Did a large "single" for apron/endcap, and "twins" between endcaps and back of tool... -
10th May 2010, 11:05 AM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
There is also a neanderthal solution, if it...
There is also a neanderthal solution, if it doesn't offend your sensibilities:)
Drill a set of holes in the same place on all the boards.Glue, run threaded rods through the holes, and tighten up... -
15th February 2010, 01:02 PM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
A word of caution: I put my faith in the rigidity...
A word of caution: I put my faith in the rigidity of a TB for my router table top. For smoothness and wear, I then added a melamine chipboard top surface, glued, and screwed round perimeter and void....
-
11th September 2008, 11:05 AM
Thread: WIP - Groggy's Workbench
by Alastair- Replies
- 1,193
- Views
- 371,621
Hi Groggy, Inclined to think along WW's...
Hi Groggy,
Inclined to think along WW's lines,; If there is no possibility of tripping over it, I still will!
Your front left is probably the least concern, as I would look at incorporating...