Search:

Don't overlook the Taiwanese clone of the old Emmert Patternmaker's Vise for $200 in the US. Should be cheaper in Australia depending on duty.

<img...

Here is the trailer mentioned in the post above. (Apologies for not having prettied it up for the photos, but it’s about 7 years old and has seen a lot of use.)

<?xml:namespace prefix = o ns =...

The tongue is made of 2 pieces of U channel so that it can fold down on itself, and is held in the trailing position by a simple Linch Pin. If storage height is no problem that feature would be...

The short answer to your question is that I don't use all of its features very often, but I do use some of them enough to justify the cost (US$200 from Woodcraft in the USA) and to accept the absence...

Hi Derek

Sharp eyes!

These chisels were among my first purchases of truly good tools. I bought them on impulse and without understanding their worth when I saw them in a small local hardware...

When we bought a house and remodeled the kitchen in 1997, I salvaged some of the old oak cabinets. One set was quickly transformed into an urgently needed bench with a top made of 2 pieces of ¾” MDF...

The ductwork took the most time, and was the most physically trying. My original setup used an 8” plenum with 4” drops to each machine. The smaller pipe proved to be a major mistake as it really...

<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" /><o:p> </o:p>


. <o:p></o:p>

Here’s a close-up of the 2 cartridge filters in an enclosure that enables the air to...

Good morning

I'm a Canadian living in <?xml:namespace prefix = st1 ns = "urn:schemas-microsoft-com:office:smarttags" /><st1:State><st1:place>Victoria</st1:place></st1:State>, on...